No two injectors flow exactly the same. When a common-rail injector is made or remanufactured, it is tested and given a correction code that describes how it differs from a perfect injector. The engine computer uses that code to adjust each injector's timing and fuel delivery so every cylinder gets the right amount of fuel.
Where to find the code
The code is printed or laser-etched on the injector body or on a label, usually as a string of letters and numbers or as a small 2D barcode. Different makers use different names for it, for example:
- Denso: QR code (also called ID code or correction code).
- Bosch: IMA code.
- Delphi: C2i or C3i code.
- Siemens VDO / Continental: a trim or ID code printed on the injector.
Why coding matters
If a new or reman injector is fitted without its code being entered, the engine computer keeps using the old injector's correction. The likely results are a rough idle, smoke, knocking, poor fuel economy or fault codes, and in the long run uneven wear on the engine.
How it is done
Coding is done with a scan tool that can write injector codes for your make of vehicle. The workshop enters the code for each new injector against the right cylinder, then clears codes and checks the injector correction values in live data. Some vehicles also need a learning or relearn procedure afterwards.
Older mechanical (non-common-rail) injectors don't have correction codes and don't need coding.
Calibration vs coding
Calibration happens on a test bench when the injector is made or rebuilt: the injector is adjusted and measured, and the correction code comes from those measurements. Coding is entering that code into your vehicle. You need both: a properly calibrated injector, and its code correctly entered.
Tips
- Write down each injector's code and its cylinder number before fitting.
- Fit new copper washers or seals as specified.
- If your vehicle came with injector codes stored, the old codes stay in the computer until someone changes them.
